Socket Set, Sensor and Sending Unit, 8 Piece (Astro: model 78408)
|
Socket Set, Sensor and Sending Unit, 8 Piece
SET INCLUDES:- 22mm Special Tube Socket (78408-01) - Allows the strut tower retaining nut on most European vehicles to be secured, which is a critical part of the front shock tension adjustment process. Designed to be used with R & R on oxygen sensors, Mercedes Diesel Injectors, OM604, OM605 & OM606. Designed to be used with a ½" drive tool.
- Oxygen Sensor Thread Chaser (78408-02) - Allows threads on oxygen sensor holes to be cleaned, and can also be used to clean and repair threads on exhaust oxygen sensor parts that have been damaged. Unit can also be used to clean threads on M18 x 1.5 spark plug hole. Designed to be used with ¾" hex socket or 3/8" square drive tool. IMPORTANT: Anit-seize material must be used when performing this application.
- Oxygen Sensor Wrenches Offset (2-1/8'') & Super Duty 12 & 6 Point Socket (78408-03) - Allows for the maximum accessibility to hard to reach areas when trying to remove socket sensors. The 12-point side provides the technician twice the amount of “clock angle" positions as compared to most oxygen sensors on the market. The 6 point side gives the technician a maximum holding power when attempting to remove oxygen sensors that are corroded. Unit can be used with most oxygen sensor wire/connector configurations. Designed to be used with 3/8" drive tool.
- Oxygen Sensor Socket (78408-04) - Allows for usage on most domestic and imported vehicles with oxygen sensors; the specially designed socket with side slot permits wire to be cleared. This socket is 3-7/8" long, has a 1" male hex drive on top and has a 7/8" 6 point opening. Designed to be used with a ½" square drive tool.
- 1/2" Drive x 29 x 90mm Oxygen Sensor Socket (7801-01) - Allows the removal of oil pressure sending units on late 1980 and mid 1990 GM vehicles. Designed to be used with 1/2" drive tool.
- 3/8" Drive x 7/8" x 90mm Oxygen Sensor Socket (7801-02) - Designed to remove and install vacuum switches with a 7/8" hex and some oxygen sensors. Designed to be used with 3/8" drive tool or with a 1" wrench.
- 3/8" Drive x 7/8" x 50mm Heated Oxygen Sensor Socket (7801-06) - Socket designed with slot in socket which accommodates the connectors on heat oxygen sensors. Socket has a double 1/2" drive for easy access.
- 3/8" x 7/8" x 30mm Offset Oxygen Sensor Wrench (7801-07) - Low profile design for use in tight spaces. Designed to be used with 3/8" drive tool.
|
|
|
